Jet Tools DC-1100G Instrukcja Użytkownika

Operating Instructions and Parts Manual Dust Collector Model: DC-1100A/C/RC DC-1100A/RC

10Connector Housing 5. Attach three support brackets (A, Fig. 4) to the base using six M8 x 16 hex cap bolts and six M8 flat washers (B, Fig. 4). H

11Filter Bag Installation – DC-1100A/RC Referring to Figure 7: 1. Place the hanger (A) on the hanger bracket (B). 2. Slide the filter bag loop (C)

12Collector Bag Installation – DC-1100C/RC 1. Place the ring over the top of the plastic bag and fold over the bag approximately three inches, Figur

13Electrical Connections All electrical connections must be done by a qualified electrician. All adjustments or repairs must be done with the dust

14Maintenance Never perform maintenance on this machine before turning switch off and removing plug from power source. Failure to comply may cause se

15Parts List – DC-1100A/RC Dust Collector Index No. Part No. Description Size Qty 1... 411035W ... Impeller Housing...

16Parts Breakdown – DC-1100A/RC Dust Collector

17Filter Assembly for DC-1100C/RC Models Index No. Part No. Description Size Qty 1... 331050... Handle ...

18Remote Control Breakdown for DC-1100RC Index No. Part No. Description Size Qty ... DC1100RC-100... Receiver Assembly (Items 1

19Wiring Diagram – DC-1100A/C

2This manual has been prepared for the owner and operators of JET DC-1100 Series Dust Collectors. Its purpose, aside from machine operation, is to pr

20Wiring Diagram – DC-1100RC

3Table of Contents Warranty and Service ...

4 Warnings 1. Read and understand the entire owners manual before attempting assembly or operation. 2. Read and understand the warnings posted on t

5 blahblahblah 20. Make your workshop child proof with padlocks, master switches or by removing starter keys. 21. Give your work undivided attention

6Introduction This manual is provided by JET covering the safe operation and maintenance procedures for model DC-1100 Series Dust Collectors. This ma

7Unpacking DC-1100A/RC Dust Collector 1. Remove all contents from the shipping carton. 2. Report any damage to your distributor. 3. Do not discard

8Unpacking DC-1100C/RC Dust Collector 1. Remove all contents from the shipping carton. 2. Report any damage to your distributor. 3. Do not discard

9Assembly Base 1. Install four casters to the under side of the base as pictured in Fig. 2. 2. Thread the hex nut (B, Fig. 1) onto the caster shaft.