Jet Tools HBS-814GH Instrukcja Użytkownika

Operating Instructions and Parts Manual Geared Head Horizontal Band Saw Model HBS-814GH WMH TOOL GROUP 2420 Vantage Drive Elgin, Illinois 6

10115 Volt Operation As received from the factory, your band saw is ready to operate at 115 volt power, using an outlet and a plug that look similar

11Adjustments Vise There are two sets of holes in the bed to mount the right jaw. The inner hole and slot (A, Figure 10) are used for miter cuts. The

125. The quick release function can also be used to back off the movable jaw when the cut is finished. Miter Cuts 1. For miter cuts, move the fixed

13 While performing the following steps, keep the blade from rubbing excessively on the shoulder of the wheel. Excessive rubbing will damage the whe

14Material chips or shavings are the best indicator of proper blade speed and downfeed rate. The ideal chip is thin, tightly curled and warm to the t

15Blade Replacement A general-use variable-tooth blade is provided with this metal cutting band saw. Additional blades can be used and are available

16Operation Figure 22 shows the control panel functions. The Emergency Stop shuts down all functions on the band saw. The machine will not start if t

177. Open the valve on the hydraulic cylinder to allow the bow to descend in a gradual and controlled manner. 8. The machine will shut off at the

18Troubleshooting Trouble Probable Cause Remedy No incoming power. Check plug connection. Blown electrical panel fuses. Replace fuses. Thermal ove

19Trouble Probable Cause Remedy Incorrect blade tension. Adjust accordingly (see page 12). Incorrect blade speed or downfeed rate. Adjust acccordin

2 This manual has been prepared for the owner and operators of a JET Model HBS-814GH Band Saw. Its purpose, aside from machine operation, is to promo

20Base Assembly

21Bow Assembly 202

22Parts List: HBS-814GH Band Saw Index No. Part No. Description Size Qty 1...HBS814GH-001...Base...

2382...TS-069204...Flat Washer... #10...2 83...

24166-2...HBS814GH-166-2...Bearing Cover... ...1 166-3...H

25202-5...TS-1540071...Hex Nut... M10-1.5 x P1...2 202-6...T

26Gear Box Assembly

27Parts List: Gear Box Assembly Index No. Part No. Description Size Qty ...HBS814GH-800...Gear Box Assembly...

28Electrical Control Box Assembly

29 Parts List: Electrical Control Box Assembly Index No. Part No. Description Size Qty ...HBS814GH-271A...Electrical Contro

3 Table of Contents Warranty and Service ...

30Electrical Connections

31

32 WMH Tool Group 2420 Vantage Drive Elgin, Illinois 60123 Phone: 800-274-6848 www.wmhtoolgroup.com

4 Warning 1. Read and understand the entire owners manual before attempting assembly or operation. 2. Read and understand the warnings posted on t

5 blahblahblah 20. Make your workshop child proof with padlocks, master switches or by removing starter keys. 21. Give your work undivided attention

6 Introduction This manual is provided by WMH Tool Group covering the safe operation and maintenance procedures for a JET Model HBS-814GH Horizontal

7 Unpacking Open shipping container and accessory boxes, and check for shipping damage. Report any damage immediately to your distributor and shippin

8 Installation and Assembly Remove all crating and plastic from around the band saw. Remove any lag screws or holding straps which secure the band sa

9 Shut-Off Switch Remove the screw and hex nuts which held the bow to the base during shipment. These should be retained in case of future transporta