Jet Tools 22-44 Plus Instrukcja Użytkownika

OWNER'S MANUAL 22-44 Plus Drum Sander (shown with optional accessories) WMH TOOL GROUP Consumer/Light Industrial Products Division P.O. BOX

10Fine Tuning Drum Alignment When sanding boards wider then the drum, drum alignment is critical and must be adjusted exactly level to slightly high

115. Wrap abrasive strip around the drum, being careful not to overlap the windings, see Figure 9. 6. Mark trailing end of strip where it cros

12Connecting Sander to a Dust Collector Dust collection is necessary for all drum sanders. The Performax 22-44 Plus is equipped with a 4” dust coll

13Selecting SANDSMART™ Feed Rates Begin experimenting with the feed rate set at about 40%-50% of maximum. The best feed rate will depend on a numbe

14Selecting Abrasive Grits The amount of stock to be removed is a major consideration when choosing the grit grade to start with. Grits of 24, 36,

15Cleaning Abrasive Strips A sandpaper cleaning stick may be used to remove deposits and help extend sandpaper life. To use, operate the sanding dr

16Conveyor Belt Replacement To replace the conveyor belt: 1. Disconnect the machine from the power source. Unplug motor cord from control box. 2

17Troubleshooting Guide Problem Possible Cause Solution Conveyor belt does not move. Shaft coupler not attached. Attach shaft coupler. Conveyor ro

18Drum Head Assembly

19Drum Head Assembly Index Part No. No. Description Size Qty. 1...70-4102... Motor, 1-3/4 HP, 110-120 Volt

2This manual has been prepared for the owner and operators of a 22-44 Plus Drum Sander. Its purpose, aside from machine operation, is to promote saf

2057...12-2000-04... Hex Nut ...1/4-20 ...2 58..

21Conveyor And Motor Assembly

22Conveyor And Motor Assembly Index Part No. No. Description Size Qty. 1...323759... Gear Motor...

23Wiring Diagram

3 WARNING Wear eye protection. Always keep guards in place and in proper operating condition. Do not operate the machine without the guards for an

4• ALWAYS DISCONNECT THE MACHINE FROM THE POWER SOURCE BEFORE SERVICING. • REDUCE THE RISK OF UNINTENTIONAL STARTING. Make sure the switch is i

5Grounding Instructions Caution: This tool must be grounded while in use to protect the operator from electric shock. In the event of a malfunction

6Specifications 22-44 Plus Drum Sander Stock Number...

7Contents of the Shipping Cartons 22-44 Plus Sander (Box 1) 1. Sander Assembly 1. Plastic Knob 1. TUF Tool 1. Abrasive Strip (wrapped on drum) 1. O

8Assembly and Setup If you purchased the optional Performax 22-44 Plus Stand refer its assembly instructions before proceeding with the drum and con

9Conveyor Belt Tracking Belt tracking adjustment may be necessary during break-in period to compensate for belt stretching. Abrasive belt tension m