Jet Tools HBS-1018W Instrukcja Użytkownika

- - - - - - - - -- ----- - -------..JETEQUIPMENT & TOOLSOPERATOR'S MANUALHBS-916W & 1018W Bandsawsj--..pJET EQUIPMENT &.TOOLS, INC.A

Adjusting Feed RateRate of feed is adjusted by turning the cuttingpressure control knob on the control panel. Rate offeed is important to bandsaw perf

blades are sharp to the skin! Use extracaution handling bandsaw blades!7.Install new blade making sure teeth arepointed downward in the proper cutting

1.Disconnect machine from the powersource.2.Raise saw arm to its highest position andclose cutting pressure control valve to holdsaw arm in place.3.Lo

4.Tighten two hex socket cap screws (A).5.Repeat for other blade guide assembly.6.Connect machineto power source.Guide Roller Adjustment1.Disconnect m

1.Place one end of a fish-type scale under theblade tension handle and lift the saw with theother end. The scale should indicateapproximately 18-20 Ib

To check level of gear box lubricant, place saw armin down position and allow a few minutes to passso that oil drains down. Check level in sight glass

~:cEQ)enen<"CQ)[Q"CCnsQ)I/)ns[Q/'<t"/7369-( ---~ Ii 0I2~12161-~N...~.203-1 201,_./'-~ 202W)JiJJ~

Important Information1-YEARLIMITED WARRANTYJET offers a one-year limitedwarranty on this productREPLACEMENT PARTSReplacement parts for this tool are a

it WARNING.Read and understand the entireinstruction manual before attemptingassembly or operation.All JET bandsaws are designed andintended for use b

Specifications:HBS-916WHBS-1018WStockNumber ""'" 414468 ..414473Capacity:Round at 900 9" 10"Round at 450 7-3/4" 8-1

Uncrating and CleanupNote: Read and understand the entire manual beforeattempting setup or operation.1.Finish uncrating the saw and inspectfordamage.

3.Remove shaft (A- Fig. 2) from the motor mountbracket.4.Carefully lift motor and line up holes in themotor mounting plate and the motor bracket.5.Sli

Electrical Connectionsit WARNINGAll electrical connections must be done by aqualified electrician! Failure to comply mayresult in serious injury!it WA

E.Cutting Pressure Control (E) - turn clockwiseto decrease cutting pressure. Turn counter-clockwise to increase cutting pressure.F.Hydraulic On-Off Va

Adjusting Vise Square to the Blade1.Disconnect the machine from the powersource.2.Place a machinist's square on the tableagainst the blade and th